Adjusting cup sensors

Adjusting cup sensors

  1. Take the colored cover off the top of the machine.
  2. Take the clear cover off in between the cup presser knobs.
  3. Insert cups into the loading tray (2-800 6-7000) cup sensors.
  4. Take a short Phillips head screwdriver and remove sensors. 
  5. Turn the sensor towards you and adjust the sensitivity knob as needed. 
  6. Test sensitivity with a pod, making sure both lights (orange and green) come on at the same time without any flickering. 
  7. Reinstall the sensors into the machine.
  8. Run the machine to triple check 

    • Related Articles

    • Missing Cup on Fork Failure Cause

      If you are getting a "Missing Cup on Fork" failure cause, the most likely issues are simple fixes. First, confirm that the stack count is correct. If it is set to a different number than what is being put into the machine, it will cause this error. ...

    • Cup Mode

      1.  2-Cup - This will only grab the two cups off of the top of the stack.  2. 32 Cup - This will run continuosly through the entire stack of cups

    • Unpacking your iFill Cup master case

      Set your master case on a stable work surface, then carefully flip the case upside down.     With a box cutter, cut tape on all four side edges of the case.     Once cut, carefully reposition the box right side up and pull the box top up and off the ...

    • Maintenance Menu

      When you enter the MAINTENANCE MENU there are six different buttons on the screen. Motor Jog - This allows you to move each motor forward or backward. Each of the Filling, Riser and Fork motors will have a "+" or "-" button which will move the motor ...

    • Lids Opening After Filling

      If you find that the lids on your pods are opening up after filling, the most likely culprit is that your coffee needs to degas. We recommend letting your coffee degas for two hours after grinding (not after the roast) before you fill your pods. This ...